(17) Remove two O-rings (25) from middle of
(5) Lightly coat plunger (11) with GAA, then in-
plunger (11). Discard O-rings.
stall in body (8).
(6) Install new O-ring (23) and retainer (22) in each
(18) Remove two bushings (26) from body (8).
end of body (8).
(19) Remove two O-rings (27) from each bushing
(7) Install new O-ring (21) and flatwasher (20) in
(26). Discard O-rings.
each end of body (8).
b. Inspection.
(8) Slide detent (16) over plunger (11) and install
WARNING
pin (19). Secure pin in place with spring clip (18).
Dry cleaning solvent P-D-680 is toxic and flam-
(9) Install cage (15) in spring cap (14).
mable. Wear protective gloves and use in a well
(10) Lightly coat inside of cage (15) with GAA, then
ventilated area. Avoid contact with shin, eyes, and
press balls (17) into place.
clothes and do not breathe vapors. Do not use
near open flame or excessive heat. The flash
NOTE
point is 100-138 degrees F (38-50 degrees C). If
Spring cap has an air hole drilled in it. Install
you become dizzy while using cleaning solvent,
spring cap on valve body with air hole facing port
get fresh air immediately and get medical aid. If
side of valve body.
contact with eyes is made, wash your eyes with
(11) Install spring cap (14) over detent (16). Secure
water and get medical aid immediately.
spring cap to body (8) using four screws (13).
(1) Clean all parts with dry cleaning solvent and
(12) Install new O-ring (12) in lever cap (5).
dry thoroughly.
(13) Install knuckle (2) in lever cap (5), then install
(2) Check all parts for cracks, damage, and exces-
screw (6). Leave screw loose.
sive wear. Replace all cracked, damaged, and worn parts.
(14) Position lever cap (5) for installation on body
(3) Inspect two bushings in accordance with TM
(8). Connect link assembly (10) to knuckle (2) and plunger
9-214. Replace if necessary.
(11) and secure with clip (9).
c. Assembly.
(15) Secure lever cap (5) to body (8) using four
screws (7).
(1)
Install two new O-rings (27) in each bushing
(16) Tighten screw (6).
(26).
(17) Slide clip (4) and boot (3) over lever (1).
(2)
Install two bushings (26) in body (8).
(18) Screw lever (1) into knuckle (2).
(3)
Install two new O-rings (25) in middle of plung-
er (11).
(19) Slide boot (3) over lever cap (5) and secure in
place with clip (4).
(4)
Install new O-ring (24) on each end of plunger
(11).
3