TM 5-3820-239-15
BASIC ISSUE ITEMS LIST AND MAINTENANCE
AND OPERATING SUPPLIES
Section I. INTRODUCTION
Code
Explanation
B-l. Scope
of two or more units, each of which carry
This appendix lists items which accompany
individual stock numbers and descrip-
the pneumatic drill or are required for installa-
tions and are procured and stocked and
can be assembled by units at indicated
tion, operation, or operator's maintenance.
maintenance categories.
Applied to parts and assemblies which
X
B-2. General
are not procured or stocked, the mortali-
This Basic Issue Items List is divided into
ty of which is normally below that of
the following sections:
the applicable end item, and the failure
of which should result in retirement of the
a. Basic Issue Items-Section II is a list of
end item from the supply system.
items which accompany the pneumatic drill or
X1
Applied to repair parts which are not pro-
are required for the installation, operation, or
cured or stocked, the requirement for
operator's maintenance.
which will be supplied by use of the
b. Maintenance and Operating Supplies-
next higher assembly or compenents.
X2 Applied to repair parts which are not
Section III is a listing of maintenance and
stocked. The indicated maintenance cate-
operating supplies required for initial op-
gory requiring such repair parts will
eration.
attempt to obtain them through cannibali-
zation; if not obtainable through canni-
B-3. Explanation of Columns
balization, such repair parts will be req-
The following provides an explanation of
through normal supply channels.
columns in the tabular list of Basic Issue Items,
C
Applied to repair parts authorized for local
Section II.
procurementes If not obtainable from
local procurement, such repair parts will
a. Source, Maintenance, and Recoverability
be requisitioned through normal supply
Codes (SMR), Column (1):
channels with a supporting statement of
(1) Source Code, indicates the selection
nonavailability from local procurement.
status and sources for the listed item.
G
Applied to major assemblies that are pro
Source codes are:
cured with PEMA (Procurement Equip
ment Missile Army) funds for initial
Code
Explanation
issue only to be used as exchange assem-
P
Applied to repair parts which are stocked
blies at DSU and GSU level or returned
in or supplied from GSA/DSA or Army
to depot supply level.
supply system, and authorized for use
Note. Source code is not shown on
at indicated maintenance categories.
common hardware items known to be
M
Applied to repair parts which are not pro-
readily available in Army supply chan-
cured or stocked but are to be manufac-
nels and through local procurement.
tured at indicated maintenance categories.
(2) Maintenance Code, indicates the low-
A
Applied to assemblies which are not pro
cured to stocked as such, but made up
est category of maintenance author-