TM 5-2590-512-13&P
CHAPTER 3
OPERATOR MAINTENANCE
SECTION I OPERATOR LUBRICATION INSTRUCTIONS
Para
Page
3-1
General
3-1
SECTION II. OPERATOR TROUBLESHOOTING PROCEDURES
3-2
General
3-1
SECTION III PREPARATION FOR OPERATION
3-3
Preparation for Earth Auger Use
3-1
3-4
Preparation for Backhoe Bucket Use
3-1
SECTION IV OPERATOR'S MAINTENANCE PROCEDURES
3-5
Auger Removal and Installation
3-2
3-6
Auger Teeth Rotation or Replacement
3-6
3-7
Auger Center Point Replacement
3-7
SECTION I. LUBRICATION INSTRUCTIONS
3-1. General.
There are no operator/crew lubrication requirements. Lubrication is task of Unit maintenance.
SECTION II. TROUBLESHOOTING PROCEDURES
3-2. General.
There are no troubleshooting procedures at operator level. Operator will note and report any unusual operating
conditions during PMCS.
SECTION III. PREPARATION FOR OPERATION
3-3. Preparation for Earth Auger Use.
Follow procedures in Chapter 4, paragraph 4-14, for preparation for Earth Auger Assembly Use.
3-4. Preparation for Backhoe Bucket Use.
Follow procedures in Chapter 4, paragraph 4-15, for preparation for Backhoe Bucket Use.
3-1
