TM 5-2590-512-13&P
b.
Removal (Rough ground).
1.
Shut down SEE engine
WARNING
Hydraulic pressure remains In system after SEE engine is off and could cause Auger to rotate
resulting in serious injury or death. Prior to separating quick-disconnect fittings, depressurize
system by operating all auger controls thru full range of motion.
2.
Disconnect hoses at quick-disconnect fittings at Auger Drive Unit (1). Use rags to control spilling.
3.
Attach 9 ft. rope (2), stored in SEE vehicle, to bottom of Auger (3). Stand back about 4 feet and pull on rope
as ground guide directs Auger Operator to start SEE engine and lower boom/dipper so as to allow Earth
Auger Assembly (4) to fall into horizontal position on ground.
3-4
