TM 5-2590-512-13&P
NOTE
Install hex pin (4) thru side of auger
hollow shaft (1) where raised anti-
rotation
pin
stops
are
located.
Ensure rectangle head of hex pin (4)
rests inside of pin stop.
2.
Use assistant and align both hex shafts so
that pin holes will be in line. Slide Auger
hollow hex shaft (1) over solid hex Auger
Drive Unit shaft (6) and stop when hex pin
holes line up.
3.
Insert rectangle head hex pin (4) through
aligned holes in Auger hex hollow shaft (1)
and Auger Drive Unit hex shaft (6). Install
hitch pin clip (3) with loop end pointing
toward Auger Drive Unit (5). For safety
reasons hitch pin clip is not tethered (to
prevent dropping or loosing), so use care
when removing or installing.
4. Wipe dirt from quick disconnects fittings and
connect hydraulic hoses.
5.
FOLLOW ON TASK
Check level of hydraulic fluid in SEE vehicle reservoir (TM Series 5-2420-224).
END OF TASK
3-6. Auger Teeth Rotation or Replacement.
This task covers:
a. Removal
b. Installation
Initial Setup
Tools:
Equipment Conditions:
SEE vehicle Bll
SEE vehicle engine off
Adjustable wrench Item #16.
Hydraulic System Depressurized
5120-00-264-3796
Materials and Parts:
Replacement Auger teeth in Bll., Rags
a. Removal.
WARNING
Prior to opening any hydraulic lines or fittings shut down SEE engine and move all SEE vehicle
hydraulic controls and pedals through their full range of motion to relieve system pressure.
To prevent serious injury or death from unexpected auger rotation, disconnect auger hydraulic
lines at quick disconnect fittings at top of Auger Drive Unit.
3-6
