TM 5-2590-512-13&P
NOTE
Original Setup - Hoses (2, 10) cross
on top side of boon.
Kit Install Setup - Hoses (9, 15) cross
under boom elbow.
b. Kit Installation.
NOTE
SEE
vehicle
has
backhoe
bucket
attached
during
Conversion
Kit
installation.
CAUTION
Start all fittings and hose connections
by hand to avoid stripping threads. Use
drip pans or shop rags to catch spilled
hydraulic fluid.
1.
Remove (crossed over) existing metal tube (2)
under dipper cylinder (1)
2.
Unscrew and disconnect fitting at each end of
metal tube (2). Loosen hold-down bolts of two
existing hose clamps (3) and (4). Remove and
discard metal tube (2).
3.
Assemble
adapter
(5)
into
male
quick
disconnect fitting (6). Install adapter assembly
(5 and 6), into driver side hose (7) coming from
rear of SEE.
4.
Install 30 Inch hose (8) to Curb side bucket
cylinder hose (9) where metal tube (2) was
removed. (Thin 30" hose (8) has a female
quick disconnect fitting on one end).
5.
Remove remaining metal tube (10).
6.
Assemble fitting adapter (11) into female quick
disconnect fitting (12). Install fitting adapter
assembly into curb side hose (13) coming from
rear of SEE.
7.
Install 30 inch hose (14) into driver side bucket
cylinder hose (15).
8.
Fasten top half of tube clamp (3) closest to rear
SEE vehicle by tightening bolt (17)
4-9
