TM 5-2590-512-13&P
b. Attach Auger Drive Unit.
1.
Position Auger Drive Unit (1) on ground
near dipper end (2) so that Auger hex shaft
is away from SEE and hoses are on driver's
side. Move dipper (2) into place and install
link pin (3). Install link pin (3) into side of
link with pin stop and seat oblong head
against pin stop. Install lynch pin (4).
2.
Move lynch pin (4) into locked position.
3.
Tie bucket control cylinder linkage (5) to
dipper arm bracket (6) with 6 ft. rope (7).
c. Removing And Storing Bucket Hoses.
1.
Disconnect both 30 inch backhoe bucket
cylinder hoses (8) and (9) at quick
disconnect fittings (10). Use rags to catch
fluid and wipe fittings clean.
2.
Loop
hoses
(8,9)
and
couple
quick
disconnect fittings (11) together over the
dipper cylinder (12).
3.
Remove two nuts (14) at hose clamp (13)
and remove top half of hose clamp (13).
4.
Install coupled hose assembly (8,9) so that
female part of quick disconnect fitting (11)
seats into lower half of hose clamp (13).
5.
Install top half of hose clamp (13) and nuts
(14). Tighten nuts to 3-5 lb. ft. (4-7 N•m).
NOTE
Installation of hoses into clamp is
correct when hoses are secured and
not moveable.
4-14
