TM 5-2590-512-13&P
12. Thoroughly clean driver's and curbside
boom cylinders (1,2), where safety Warning
labels are to be installed, to remove dirt, oil,
and moisture. Ensure area is dry.
13. Install one label (3) to each boom cylinder
(1,2).
14. Check and tighten all fittings (4), clamps (5),
retainers (6) on boom and dipper installed
from Kit.
15. Check hydraulic reservoir fluid level in SEE
vehicle and replace any fluid lost during
installation. (Reference SEE TM Series 5-
2420-224).
NOTE
Clean up fluid spills on fittings,
hoses, and around area.
d. Conclusion.
1.
Start SEE vehicle engine.
2.
Visually examine kit installation parts for
leaks from hoses at fittings. If there are any
leaks, shut down SEE engine and tighten
fittings.
3.
Pull bucket control lever towards you.
Ensure bucket curls towards operator (see
para 2-2 Controls).
4.
Move bucket control lever away from you.
Ensure bucket uncurls away from operator.
NOTE
If controls work in reverse, hoses
were not crossed during installation.
Check
steps
in
Kit
installation
procedures.
5.
Operate bucket controls thru full range of
motion and have assistant look for hose
binding or stretching. Adjust clamp if
necessary (see NOTE on previous page).
NOTE
This completes one-time conversion
kit
installation.
SEE
may
be
switched from Earth Auger Assembly
use to Backhoe Bucket use, quickly,
and easily.
4-12
