(17) Remove two O-rings (25) from middle of
plunger (11). Discard O-rings.
(18) Remove two bushings (26) from body (8).
(19) Remove two O-rings (27) from each bushing
(26). Discard O-rings.
b. Inspection.
WARNING
Dry cleaning solvent P-D-680 is toxic and flam-
mable. Wear protective gloves and use in a well
ventilated area. Avoid contact with shin, eyes, and
clothes and do not breathe vapors. Do not use
near open flame or excessive heat. The flash
point is 100-138 degrees F (38-50 degrees C). If
you become dizzy while using cleaning solvent,
get fresh air immediately and get medical aid. If
contact with eyes is made, wash your eyes with
water and get medical aid immediately.
(1)
Clean all parts with dry cleaning solvent and
dry thoroughly.
(2)
Check all parts for cracks, damage, and exces-
sive wear. Replace all cracked, damaged, and worn parts.
(3)
Inspect two bushings in accordance with TM
9-214. Replace if necessary.
c. Assembly.
(1)
Install two new O-rings (27) in each bushing
(26).
(2)
Install two bushings (26) in body (8).
(3)
Install two new O-rings (25) in middle of plung-
er (11).
(4)
Install new O-ring (24) on each end of plunger
(11).
(5)
Lightly coat plunger (11) with GAA, then in-
stall in body (8).
(6)
Install new O-ring (23) and retainer (22) in each
end of body (8).
(7)
Install new O-ring (21) and flatwasher (20) in
each end of body (8).
(8)
Slide detent (16) over plunger (11) and install
pin (19). Secure pin in place with spring clip (18).
(9)
Install cage (15) in spring cap (14).
(10) Lightly coat inside of cage (15) with GAA, then
press balls (17) into place.
NOTE
Spring cap has an air hole drilled in it. Install
spring cap on valve body with air hole facing port
side of valve body.
(11) Install spring cap (14) over detent (16). Secure
spring cap to body (8) using four screws (13).
(12) Install new O-ring (12) in lever cap (5).
(13) Install knuckle (2) in lever cap (5), then install
screw (6). Leave screw loose.
(14) Position lever cap (5) for installation on body
(8). Connect link assembly (10) to knuckle (2) and plunger
(11) and secure with clip (9).
(15) Secure lever cap (5) to body (8) using four
screws (7).
(16) Tighten screw (6).
(17) Slide clip (4) and boot (3) over lever (1).
(18) Screw lever (1) into knuckle (2).
(19) Slide boot (3) over lever cap (5) and secure in
place with clip (4).
(20) Install valve (see TM 5-3820-241-12).
3
