Page 2-3. Figure 2-1, sheet 2.1 of 3, is added after
sheet 2 of 3:
Figure 2-1. Controls and instruments (for units equipped
with retrofit kit) (sheet 2.1 of 3).
Page 2-11. Figure 2-8.1 is added as follows:
Figure 2-8.1. Drilling operation (for units equipped with
retrofit kit).
Page 3-1. Chapter 3, Section II is superseded as
follows:
Section II. OPERATOR’S PREVENTIVE MAINTENANCE CHECKS AND SERVICES
3-3.
Introduction
a.
General. Table 3-1 (PMCS Table) has been
provided so you can keep your equipment in good
operating condition and ready for its primary mission.
b.
Warnings and Cautions. Always
observe the WARNINGS and CAUTIONS appearing in
your PMCS table. Warnings and cautions appear before
applicable procedures. You must observe these
WARNINGS and CAUTIONS to prevent serious injury to
yourself and others or to prevent your equipment from
being damaged.
c.
Explanation of Table Entries.
(1)
Item Number Column. Numbers in this
column are for reference. When completing DA Form
2404
(Equipment
Maintenance
and
Inspection
,Worksheet),
include
the
item
number
for
the
check/service indicating a fault. Item numbers also
appear in the order that you must do checks and
services.
3
